繁體：定時電阻器
定时电阻器是用于建立精确时间常数的无源电子元件。
定时电阻器是被动电子元件，专门设计用于在脉冲发生电路中建立精确的时间常数。它们与电容器配合形成RC（电阻-电容）网络，决定生成信号的频率、脉冲宽度和定时特性。这些电阻器必须在时间和温度变化下保持稳定的电阻值，以确保工业应用中一致的定时性能。 定时电阻器基于欧姆定律（V=IR）在RC定时电路中工作。当与电容器结合时，它们产生时间常数（τ = R×C），决定电容器充电和放电的速度。这种充放电循环产生精确的定时间隔，控制电子信号中的脉冲宽度、频率和延迟。电阻值直接影响定时特性，较高的电阻值产生较长的时间常数，较低的电阻值产生较短的时间常数。
诱因 → 失效模式 → 工程缓解
不是客户评论，也不是实时热度。以下维度用于前期 RFQ 准备和供应商评估。
这些分值是采购评估维度示例，不代表真实客户评分、具体国家买家反馈或实时询盘。
Timing resistors have much tighter tolerances (typically ±0.1% to ±1% vs ±5% for regular resistors), lower temperature coefficients, and better long-term stability. They are specifically designed to maintain precise resistance values over time and temperature variations, which is critical for accurate timing in pulse generation circuits.
Consider the required time constant (τ = R×C), temperature stability needs, power dissipation requirements, and environmental conditions. Choose resistors with appropriate tolerance (±0.1% to ±1%), low temperature coefficient (5-50ppm/°C), and sufficient power rating. Also consider the resistor's long-term stability and voltage rating for your specific circuit requirements.
Yes, but with limitations. Metal film timing resistors typically perform well up to several hundred MHz, while wire-wound resistors have more parasitic inductance and are less suitable for high-frequency applications. For very high frequencies, consider surface mount devices (SMDs) with minimal parasitic effects.
CNFX 是开放目录，不是交易平台或采购代理。工厂资料和表单用于帮助你准备直接沟通。
CNFX 制造商资料、技术分类、公开产品信息和持续合理性检查。
说明目标数量、应用场景、交期和关键技术要求，用于准备 RFQ 或供应商评估。